Edge Guard Fit Guide

Choose your edge guard size based on your paddle’s core thickness

S • 0.800"
Best for: 12mm paddles

M • 0.875"
Best for: 14mm paddles

L • 0.950"
Best for: 16mm paddles

Unsure? Tell us your paddle model & size and we’ll do our best to help you acquire the perfect fit.

Because paddle manufacturers use different standards for reporting core and edge-guard thickness, sizing can vary slightly between brands. We’re consistently updating and refining our guide as we collect more real-world measurements to give you the most accurate recommendations possible.

Simple Install Steps

Clean the paddle edge

Use an alcohol pad or rubbing alcohol and a gray or black microfiber towel.
(Avoid yellow towels — dye can transfer onto lighter paddles.)

Begin at the top of the grip
Start wrapping right above the handle/neck area while holding the paddle upside down.

Work slowly around the paddle
Pull 4–5 inches of backing at a time as you wrap.

Press with your thumb
Always push from the section that is already set toward the section that has not been set.

During the wrap, create an even overlap
Ensure the overlap is even on both the left and right sides, then finish setting that area by pressing from the outside edge onto the face for a clean, secure seal.

Trim any excess film
Use a sharp blade to cleanly trim excess material — or make a small mark with a pen, lift the vinyl, make your cut, and then set the material back down for a smooth finish.

Optional Step (for older paddles)

Refresh worn edges
For older paddles with chips or rough spots, lightly sand the edge with 800–1000 grit sandpaper before wrapping. This creates a smooth underside and helps the vinyl sit flawlessly.